Guide to second-hand housing decoration decoration

2022-07-22
  • Detail

Compared with the decoration of new houses, the decoration of second-hand houses has more unpredictable troubles, and some parts of the decoration of second-hand houses must be demolished and some cannot be moved, which are stipulated. In other words, the decoration of a second-hand house will further test the overall planning ability of the owner. The decoration of second-hand houses can be divided into the following four steps:

compared with the decoration of new houses, the decoration of second-hand houses has more unpredictable troubles, and some parts of the decoration of second-hand houses must be demolished and some cannot be moved, which are stipulated. In other words, the decoration of a second-hand house will further test the overall planning ability of the owner. The decoration of second-hand houses can be divided into the following four steps:

Kono ·, Germany; Rhine sunshine

first, structural optimization

1. Before the decoration of second-hand houses and old houses, some structural layout optimization should be carried out according to the actual situation of the house to make full use of the wasted space

2. Dismantle and transform some partition walls (non load-bearing walls), wall cabinets, top cabinets, etc., and increase and improve the lighting and utilization rate

II. Waterway optimization

1. Add some water inlets, outlets and drains according to the locations of showers, wash basins, toilets, washing machines, vegetable basins, mop basins, water purifiers, electric water heaters and gas water heaters

2. Replace the old pipelines with PPR pipes (preferably PPR composite copper pipes) with concealed pipes

3. The old valve cannot be closed tightly, which is neither beautiful nor easy to use. It is best to replace it with a vacuum copper ball valve with reliable quality

III. circuit optimization

1. In many buildings around the 1990s, lighting and sockets are mixed with a circuit, and the wire is aluminum core wire or 1. 5 square meters of copper core wire, once several electrical appliances are opened at the same time or which electrical appliance leaks electricity, the main switch will jump, causing other electrical appliances to be unable to operate normally. In addition, the circuits of these old houses have no grounding protection, which can not effectively prevent the accidental injury to human body caused by circuit aging or leakage after short circuit, which is more in need of thorough transformation

2. At the end of last century, the government carried out capacity increase treatment for the strong current system of some old buildings, but the capacity increase part is generally limited to the air conditioning circuit, which can basically ensure the use. However, most of these capacity increase cables are routed in trunking or directly outside the wall with three-phase sheathed wires, which seriously affects the overall aesthetics of the wall, and these lines should also be transformed into dark lines

3. These old houses; The distribution box setting of old houses is generally old, the circuit is too simple, and the power ratio of each circuit is not reasonable. It is necessary to plan a safe and reasonable circuit design according to the power of all electrical equipment. Ideally, there should be five switch circuits in the distribution box: main switch, lighting, ordinary socket, air conditioner, kitchen and bathroom socket. If there is a fast heating water heater, a separate circuit with a 6 square meter copper core wire needs to be added

4. With more and more household appliances and lamps, there are many places where switches and sockets need to be placed. Before decoration, we must do the wiring work well in advance, and plan in advance what electrical appliances need to be placed in the future. However, the reserved switches and sockets in old houses are generally not enough

generally speaking, a room should be equipped with at least 3 sockets, and the number of sockets in a two bedroom residence should be no less than 15, and the number of switches should be no less than 8. The switch height in the same room should be the same. Generally, the lower part of the switch is 1 away from the ground. 4 meters. The lower part of the socket is 0 from the ground. 3 meters, all switches should be set at a place that is easily accessible

IV. overall reform of second-hand housing renovation:

First: there are many ways to improve the ground. The first is ground disinfection. To completely disinfect, spray with 3% Lysol water, 1%-3% bleach water or 3% Peracetic acid solution. After sprinkling, close the window for 1 hour

second: the renovation of the wall of second-hand houses. In the 1990s, wall decoration was popular with plastic spraying. If you touch the plastic sprayed wall, you should shovel it off and start again. After handling the wall, brush the primer, and then brush the emulsion paint finish. If it were wallpaper, it would be much easier

third: the door and window facade can be improved properly, which can save a lot of money. You can continue to use the original owner's door, but you need to make some decoration, such as adding some lines to the original door, or you can use the original door as a blank and change a style to beautify it. The simplest way is to paint the original door with beautiful colors

西安银屑病医院

西安妇科医院

常州男科医院

Copyright © 2011 JIN SHI